Google+ Antique GPO Telephones & British Vintage Telephones: Fix for a Slow dial on 746 Telephones and 706 Telephones

Thursday, February 02, 2017

Fix for a Slow dial on 746 Telephones and 706 Telephones

Vintage 746 telephone and 706 telephone dials are lovely mechanical devices (similar in many ways to antique clocks) however they can start to run slow over time (usually many years). The instructions below explain how to clean/lubricate the speed governor in these antique telephones to fix a slow running dial.


To Access the Vintage Phone Dial Mechanism


1) Place a piece of sticky tape over the clear centre dial cover and pull if off quickly to safely remove the clear plastic centre dial cover.

This process is shown in the picture below:



2) Remove the paper label and then unscrew the screw in the centre of the telephone dial, to remove the clear plastic (with a flat blade screwdriver).



3) Remove the small wire retaining clip from the telephone dial, this is easily removed with your fingers (see picture below)


4) Lift out the 746 telephone number plate backing (using a piece of sticky tape).


5) The inside of the vintage dial will look very similar to the photograph below. However although the inside parts will be the same shape they may well be different colours. Some parts of the telephone dial mechanism may be plastic, others may be brass (especially in the 706 Telephones).

6) Then apply a small amount of thin "watchmaker’s oil" onto a cotton bud and use the cotton bud to clean out the dial governor cap. NEVER use WD40 as this will cause the dial to fail in a few months, its one of the worst thing you can use on these vintage telephone dials. Cleaning the telephone governor is far more important than lubricating, so make sure you are patient an remove all the grime.

Note: If you have access to fully evaporating cleaning solvents (such as alcohol) clean out the telephone dial governor cap first before lubricating with watchmakers oil, again use a cotton bud for this.



7) Move the cotton bud from side to side to get to the complete insides of the cup (see above and below).



8) Then replace the telephone Number dial backing (see below).



9) Replace the small wire retaining clip (see below).






10) Replace the clear plastic finger dial and centre screw and tighten the screw (see below).


11) Test that the vintage telephone dial rotates OK (to make sure the procedure has worked) and then finally replace the paper label and push fit the plastic centre cover. Then test the dial again.



All should now be OK with the vintage telephone dial. A simple repair on the UK's nostalgic 746 Telephone. This process should work at least 70% of the time. If this procedure does not solve your telephone dial speed problem you may have to contact a vintage telephone restorer for help or advice. Good antique telephone restorers also have access to telephone dial testing and speed / ratio calibration equipment.

5 comments:

Ida said...

Thank you for your comment and nice words on my blog.
It`s appreciated. :)

I remember phones like this from my childhood days here in Norway. Grey ones.

colm said...

Hi I have a working bakalite phone I want to use at a festival (in a bar playing old music and gramophones).
would you have any information on getting it to work away from the land line?
regards,
Colm

Dusty said...

Will take your comments onboard regarding Trimphone.Like your blog very informative well done.

TSI Home Phone said...

what to say... Old is Really Gold, I am missing my old days. Phones are special in every ones life and I must say its awesome...thanks :)

Uberlaser said...

Thank you very much for the information and useful picture guide.
I cleaned up an old GPO telephone that I bought from a car-boot sale that wasn't rotating properly, and now it works a treat!